5″ Insulated 30 Degree Elbow Set


This set of two elbows allows you to offset your insulated chimney pipe and return to vertical with two 30-degree turns. One end is male (crimped) and the other female.

Don’t forget clamps! Every pipe joint needs to be secured with either a clamp or three stovepipe screws. We recommend ordering a pipe clamp along with each section of flue pipe.

30 degrees is the maximum allowed angle for an elbow in a chimney pipe.  More severe angles like 45 and 90 degree bends are available in our single-wall connector pipe.

Availability: Only 3 left in stock

SKU: 5"SSDW30 Category:

Set of two 30-degree elbows.  Made from .5mm Stainless Steel 316 Inner Wall / Stainless Steel 304 Outer with ceramic insulation.  Clamps are sold separately.

You can connect these two elbows together for a small offset of approximately 3.5″. Add insulated pipe in between for a larger offset.

  • Elbows with 10″ pipe between will give a horizontal offset of 7.75″
  • Elbows with 20″ pipe between will give a horizontal offset of 12.75″
  • Elbows with 30″ pipe between will give a horizontal offset of 17.75″
  • Elbows with 40″ pipe between will give a horizontal offset of 22.75″

⚠ Warning: California Proposition 65

Use of this product can expose you to chemicals including soot, creosote, wood dust, and wood smoke containing carbon monoxide, which are known to the State of California to cause cancer, birth defects, or other reproductive harm.  For more information, visit www.P65Warnings.ca.gov.


Weight .25 oz

Share your thoughts!

Let us know what you think...

What others are saying

There are no contributions yet.



Continue as a Guest

You may also like…

Scroll to Top