3” Stove Pipe 90 Degree Elbow

This fitting changes the direction of your stovepipe by 90 degrees. One end is male (crimped) and the other female. If you need a part to connect to the rear exit of your stove, don’t use a 90.  Use the rear exit kit instead.

Don’t forget clamps! Every pipe joint needs to be secured with either a clamp or three stovepipe screws. We recommend ordering a pipe clamp along with each section of flue pipe.

Wall Exit? If you want a piece to run your flue out the wall, you won’t be able to safely do it with the parts we offer. Due to the challenge of getting a strong draft with 3″ diameter pipe, we recommend having your flue pipe exit your roof. We feel so strongly about it, we don’t even offer the parts you would need for a 3″ wall exit installation. Please NEVER use single-wall pipe to penetrate your wall/roof and don’t use it for any exterior portion of your flue.

The female end of this fitting also fits nicely over our Direct-Air kit for a more robust air supply pipe than aluminum dryer vent from the hardware store.  The Male end of this fitting fits inside the Salamander Hobbit direct air kit.