Description
This kit is for venting 4” stoves like: The Dwarf 4kw or 3kW Standard, Salamander Hobbit, Navigator Cod & Sardine out the roof of relatively flat roofs (like RV’s & buses). Since every installation is a little bit different single wall pipe is not included in this kit (except for the short telescoping section).
Note: Since every installation is a little bit different you will need additional single wall pipe and may need additional double-wall pipe to complete your installation. Simply measure the distance from your stove’s flue flange to where the pipe will exit the roof then subtract 10″. This is the amount of single wall pipe you will need. The single wall telescoping pipe included in the kit allows for easy installation by stretching or shrinking the pipe to connect the stove to the chimney pipe.
This kit will put the roof vent approximately 16-18″ above where it exits the roof. You will need additional insulated pipe if you would like to extend higher than 18”. Insulated pipe is recommended for use outside the structure to keep flue gases hot.
Typically you want your roof vent to be above the peak of your roof line so wind gusts do not come over the top of your roof then down the vent pipe. Keeping your vent above the roof line helps prevent backdrafts. On relatively flat roofs like RV this isn’t an issue.
Code for residential installation says, “ 3 ft minimum from roof penetration and 2 ft minimum above highest point of anything within 10 ft.”
Reviews
There are no reviews yet.