Fits Pipe Outside Diameter: 6″ – 11″
Base Dimensions 14″ x 14″
Features a flexible aluminum base for forming boot to fit over corrugated roofs.
Boot is sealed (any sealer that is recommended for silicone + your roof surface) then screwed to roof surface.
This pipe boot is best used with our 4″ & 5″ Insulated Pipe. Our smaller round pipe boot will work with 4″ insulated pipe depending on your roof pitch. This boot gives 4″ pipe more space for steeper pitched roofs.
Pitch Limitations:
4″ Insulated Pipe: 7/12 with 2″ clearance, 7/12 with zero clearance – limitation due to boot’s inability to bend at steeper angles
5″ Insulated Pipe: 2/12 with 2″ clearance, 7/12 with zero clearance
Any combustible materials must be removed to 2″ away from the insulated pipe passing through the roof. A non-combustible roof (e.g. a metal roof with no wood sheathing underneath) can be cut closer to the pipe, but not touching.
⚠ Warning: California Proposition 65
Use of this product can expose you to chemicals including soot, creosote, wood dust, and wood smoke containing carbon monoxide, which are known to the State of California to cause cancer, birth defects, or other reproductive harm. For more information, visit www.P65Warnings.ca.gov.
brett (verified owner) –
This boot is one of the few available in silicone in a really nice gray color. I have a moss green yurt with grey accents and a white roof. This boot worked perfectly to seal the opening as well as keeping with a clean look. It made a super tight seal around my double wall pipe exiting out the wall and I was able to use a series of bolts and weather sealant around the edge to made a really tight fit through the wall. This not only looks great but also probably saved me quite a bit of time.
Upvote if this was helpful (0) Downvote if this was not helpful (0) Watch Unwatch Flag for removal
Question
Jonathan Puderbaugh (verified owner) –
Is this rated for wood stove pipe
Upvote if this was helpful (0) Downvote if this was not helpful (0) Watch Unwatch Flag for removal
Dan –
Jonathan- Yes, this high-temp silicone pipe boot is designed for use with Class A pipe (i.e. wood stove chimney pipe), which will be double-wall insulated or triple wall pipe. Single-wall stovepipe could easily exceed the temperature rating on this boot, but single-wall pipe isn’t permitted to be used for a roof penetration. As long as you’re using proper Class A chimney pipe, this boot is a good choice.
Upvote if this was helpful (0) Downvote if this was not helpful (0) Flag for removal
Question
Me (verified owner) –
Would this work for a 6″ exterior pipe ( Double wall.
Stove’s Manual says 6 ” pipe only.
I’m guessing that is the outside diameter..)
Upvote if this was helpful (0) Downvote if this was not helpful (0) Watch Unwatch Flag for removal
Kayla Addison (verified owner) –
The boot fits pipe with an outer diameter of 6″ to 11″. Keep in mind that the larger the pipe, the less boot you’ll have left after trimming it. That means you wouldn’t be able to use it on a roof with a decently steep roof pitch if you cut it down.
-Kayla
Upvote if this was helpful (0) Downvote if this was not helpful (0) Flag for removal